Tube Squeezing And Sizing Membrane Panel Machine C-type frame

Tube Squeezing And Sizing Membrane Panel Machine C-type frame

This equipment is designed simply as C type and has 9 oil cylinders for hydraulic drive.
It is used to squeeze and calibrate small heated elbow on the same level. A qualified 180°elbow of Φ=76mm thickness=12.7mm R=1.5D can be squeeze to R=0.6D and achieve technical requirement.

Constitute:

1 C-type frame (lathe bed)
2 Calibration tank max180t
3 Backpressure tank
4 Right extrusion mechanism
5 Left extrusion mechanism
6 Up/down of under mode calibrated by slide
Mainly uses Mitsubishi PLC control, heating control in the same panel, simple operation, low failure rate.

Paraweter:

1 Pipe diameter: D = Φ32-Φ76
2 Pipe thickness: 3 ~ 12.7mm
3 The bend radius of 180° elbow before squeezing : R = 1.5D
4 The bend radius of 180° elbow after squeezing : R = (0.6 ~ 1.2) D
5 The maximum open distance of clamp made : L = 400mm
6 Squeeze pressure :F= 45t
7 Calibration pressure : F= 120t
8 Hydraulic system pressure :N = 16Mpa
9 Pump power : N = 18.5kw

Flat bar finishing machine

Panel Production Line

Tube Squeezing And Sizing Membrane Panel Machine C-type frame Images